The cutting efficiency of rusty plates will be reduced, the effect will be poor, and the scrap rate will be higher. If possible, reduce the use of rusty plates or deal with rusty plates.
The greater damage is actually the hole blasting during punching and cutting, which will cause pollution to the lens. You can use a grinder to remove rust first. If the plate is not thick, the effect below 5mm will not be significant, but the quality of the cut product will be affected. The failure rate is high.
The cutting condition of the overall uniformly rusted plate will be better than the unevenly rusted plate. Because the uniformly rusty sheet absorbs the laser evenly, it can be cut well. For the processing of materials with uneven rust on the surface, the surface condition of the material must be uniform before cutting.