Method 1: Clean the lens of the metal laser cutting machine. First bend the lens cleaning paper into several folds, soak it with a small amount of analytical pure acetone, and then gently wipe the surface of the lens with the soaked lens paper. Please be careful not to press the lens with your fingers. Please wipe the lens several times until the surface of the lens is clean and there are no dirt or remaining marks on the mirror surface. Dry it again and roll the lens paper moistened with a few drops of acetone into a rod. Gently scrub the surface of the lens to remove heavy dirt. drop. When using acetone, please prevent it from absorbing excessive moisture from the air and causing its deterioration and pollution, so it must be sealed and stored. Do not mix the used acetone solution with the original bottle. You should follow the principle of pour as much as you want. Pour away if you can't use it up.
Method 2: Clean the mirror lens of the metal laser cutting machine. First remove the lens, pad the mirror surface with paper so that the mirror surface is facing up, and put a few drops of acetone on the paper and then gently pull the paper over the mirror surface. Repeat the above actions several times until the mirror surface is clean and free of dirt, and then put the lens into the lens holder.